Note:- This cheat is also known as Gamecube
Systems
Alternate starting sounds - Hold Z while the Gamecube logo appears to
hear new sounds.
Hold Z then about one second later hold A to hear another sound.
Insert four controllers then hold Z on each of them while the Gamecube
logo appears to hear different sounds.
Change screen refresh rate - Hold B while powering on the system until
the message "Would you like to switch to 50hz mode?" appears. This
allows you to switch the screen refresh to match that of PAL games. If
playing on a PAL system, the message will be "Would you like to switch
to 60hz mode?", allowing the screen refresh to match that of NTSC games.
Control starting logo - Hold A while the cube bounces down to form the
"G" logo to spin it.
Set system time and options - Hold A while powering on the system.
Sent in by Mark Tiller
Change screen refresh rate: Hold B while powering
on the system until the message "Would you like to switch to 50hz
mode?" appears. This allows you to switch the screen refresh to match
that of PAL games. If playing on a PAL system, the message will be
"Would you like to switch to 60hz mode?", allowing the screen refresh
to match that of NTSC games.
In-game reset: To restart the Gamecube in many games, hold B + Y
+ Start at the title screen.
Use the Game Boy Advance to Gamecube link option without a Game Boy
Advance: This trick requires two Gamecubes, two televisions, and
at least one Game Boy Player. The purpose of this trick is to
eliminate the need for a Game Boy Advance and also use the special
function it provides on a television screen. Attach the Game Boy
Advance to Gamecube cable into the link cable slot in the Game Boy
Player (without a game in it) that is attached to the other Gamecube
(on which the game with the special options is played, such as the
Tingle Tuner on Legend Of Zelda: The Wind Waker) or put in the
required game that may be required for other options (such as the
Metroid Prime and Metroid Fusion hookup). |